Semi-Automatic Checking Fixtures
Checking fixtures are equipped with AirTAC Cylinders, can achieve automatic clamping and checking.
These are Semi-Automatic Checking Fixtures which are going to be used for checking casting aluminum parts of TESLA. There are 8 sets of fixtures in total.
Part Name: TESLA RREAR-SIDE CASTING
Checking Fixture Size : 1450*980*1180mm
Project Name: Model X&S
Total Quality: 8 Sets
Semi-Automatic and Pneumatic Checking Fixtures
Checking Fixtures for Casting Aluminum Parts
Main Construction: Aluminum
Base Plate: Original Color of Mental
The Steel and Aluminum Parts: Original Color of Mental
1.The Measuring Datum ±0.02mm
2.The Flatness of Base Plate 0.05/1000
3.The Thickness of Base Plate ±0.03mm
4.The Location Datum ±0.05mm
5.The Surface ±0.1mm
6.The Checking Pins and Holes ±0.1mm
Part of the measuring report:
Part Loading and Inspection Operation:
1. Put the part on the datum A1, A2, A3, B1, B2, C1, adjust the part to make it well contact contact datum.
2. Close the clamps 1, 2, 3
3. Use the gap gauge GO φ4.5 NOGO φ5.5 to check the part trimming profile.
4. Open the pneumatic device and make it move forward in place. Use gap gauge to inspect part profile per inspection order.
5. Close the pneumatic device after the inspection is completed. When the pneumatic device is retracted in place, open the clamps and remove the part.
Final Inspection and Buy-off at Quality Department