TTM19160 checking fixture has high measurement accuracy, no fear of deformation, low maintenance cost and good convenience. Key product characteristic inspection, characteristic line inspection, function hole inspection, area detection which is prone to deformation in assembly process, for automobile assembly and production function matching inspection. In the production process of automotive parts, on-line inspection of automotive parts is realized, which ensures the rapid judgment of the quality status of automotive parts in production, ensures the safety and processing speed of automotive assembly, and improves the quality of automotive parts.
|1.Verity that all clamps are in the open position , take out the stop pinB, use the taper side to locate.|
|2.Put the part alignment with B pin, steady put part on the C , frist close the clamps 1,then close the clamps 2,3, finished the part location.|
|3.GO/NOGO check part relevant hole size , profile GO/NOG and step pin check part surface profile and trim profile.|
|4.Finish the single part check ,frist open the clamps 2,then open the clamps 1,3, , take out the part.|
|5.wipe fixture clean after use and check for dotects.|